Wheeler Delta Series AR-15 Hammer & Roll Pin Punch Set - Black Steel

The Wheeler Delta Series AR-15 Hammer & Roll Pin Punch Set is a purpose-built gunsmith kit that gives you every tool needed to drive the roll pins on an AR-15 without marring the receiver, trigger guard, or bolt catch. At the core of the kit is a two-sided chrome-plated steel hammer with nylon and brass heads on opposing faces, letting you choose the right strike for each pin during a build or repair.

Two AR-specific alignment fixtures are included: the Bolt Catch Install Tool Kit, machined flat on one side for correct alignment, and the AR-15 Trigger Guard Install Tool, sized to seat the guard roll pins. Three starter punches open the way into the receiver pin channel, and three matched driver punches drive each roll pin home. Six additional steel bench punches round out the set for general gunsmithing work. Every component is sized for AR-pattern rifles and mil-spec roll pins.

A custom-fit storage case keeps each tool indexed on your bench, so you can grab the right punch and the right fixture quickly when assembling a stripped lower, replacing a worn guard, or fitting a complete duty rifle. Whether you are doing a one-off build or maintaining an armorer-level shop, the Wheeler Delta Series Roll Pin Install Tool Kit brings the correct installation hardware together in one organized package.

Kit Contents:

• Bolt Catch Install Tool Kit
• AR-15 Trigger Guard Install Tool
• 3 Starter Punches
• 3 Driver Punches
• Two-Sided Chrome-Plated Steel Hammer (nylon / brass heads)
• 6 Steel Bench Punches
• Custom-Fit Storage Case