RCBS Pow'r Pull Standard Chuck Assembly - Replacement 3-Jaw Chuck

The RCBS Pow'r Pull Standard Chuck Assembly is the genuine factory replacement 3-jaw case-holding chuck for the RCBS Pow'r Pull kinetic (inertia) bullet puller. If the original chuck on your Pow'r Pull has been lost, damaged, or simply worn out, this RCBS service part restores full function to your bullet-pulling setup so you can salvage loaded rounds and recover components for reuse.

The standard chuck covers the broad middle of the cartridge range, accepting everything from small cases like the 5.7x28mm and .22 Hornet up through the large Winchester-family bottleneck cases used in popular hunting and target loads. It pairs with the Pow'r Pull hammer-style handle and the 3-jaw collet design: insert a loaded cartridge, tighten the cap, and strike the handle against a firm surface to drive the bullet out without damaging the brass, jacket, or powder charge.

The chuck threads directly into the Pow'r Pull body in place of the original. A sealed rubber O-ring and spring-steel detent hold the jaws aligned for smooth case insertion and reliable grip on a wide range of case diameters. For belted magnums and Winchester Short Magnums that exceed the standard chuck's grip range, RCBS offers a dedicated Magnum Chuck Assembly (sold separately).

Features:

• Genuine RCBS replacement part, MPN 09418
• 3-jaw self-centering case-holding chuck for the RCBS Pow'r Pull kinetic bullet puller
• Standard grip range covers small cases (5.7x28mm, .22 Hornet) up through large Winchester bottleneck cartridges
• Rubber O-ring and spring-steel detent for smooth, consistent jaw alignment
• Threads directly into the Pow'r Pull body for quick swap-out
• Removes bullets without damaging brass, bullet jackets, or powder charges for component reuse