Rare 1960 Polish KBK wz. 1960 Parts Kit – Milled - Underfolder Stock, Type 3, Original Polish Barrel in 7.62x39mm (Non-Matching numbers #13666)
"Small Batch" alert: we are first to bring to market a limited run of KBK wz. rifles still wearing their torch-cut Type 3 receivers and intact factory barrels. Every kit is listed individually, so what you see is exactly what you get.
This set is a 1960-dated, Circle 11-stamped Polish AK-47 that left Radom's famed Łucznik factory before Poland transitioned to stamped AKMs. It retains non-matching serial numbers #13666 (Only dust cover does not match!) – receiver stub, bolt, bolt-carrier, and recoil spring all roll-marked alike. The original cold-hammer-forged barrel remains pinned in the trunnion with strong, bright rifling.
KBK is short for Karabinek—Polish for "carbine." The model code wz. 1960 ("wzór 1960" = "Pattern 1960") identifies Poland's license-built Type 3 AK with a machined receiver. Produced in relatively small numbers from 1957-1962, these rifles bridged the gap between the Soviet Type 3 and the stamped-receiver AKM. While most were fixed-stock models, a small number were produced with a milled underfolder stock, making this variant particularly desirable. Because most were rebuilt or used for AKM conversions in the late 1960s, matching KBK wz. 1960 kits are exceptionally scarce today.
Original Features
- Caliber 7.62x39mm
- Machined / milled Type 3 receiver (torch-cut per ATF spec, small cut section has been removed)
- Complete populated barrel assembly with factory front-sight & gas blocks
-
Underfolder Stock & Bakelite pistol grip
- Factory code "11" and selector markings ("C" full-auto / "P" semi) on receiver stub
This Kit Includes (exactly what's in the photos)
-
Complete barrel assembly – still in original trunnion, Circle 11 / 1960 on chamber
- Wooden handguards (upper & lower)
- Milled torch-cut receiver section, small cut section has been removed.
- Barrel Nut protecting muzzle threads.
- Strong rifling
- Complete front and rear sights
- Complete underfolding stock assembly
- Cleaning Rod
- Mag-catch assembly
- Recoil-spring assembly
- Bakelite pistol grip + grip screw
- Dust cover
- Bolt & bolt-carrier
- Safety / selector lever
- Disconnector
- Hammer & hammer spring
- Trigger
- Axis pins
Condition: GOOD CONDITION.
Supply is extremely limited – Don't miss the chance to build or preserve a true piece of Cold-War history.
NOTE: All parts must be inspected and installed by a qualified gunsmith. Receiver pieces are sold as historical artifacts only.
DISCLAIMER: Parts kits are subject to state-specific shipping restrictions and cannot be shipped to California, Connecticut, Hawaii, Illinois, Maryland, Massachusetts, New Jersey, New York, or Washington. Please visit our shipping restrictions page to review all applicable restrictions for your state. Subject to change.
