CAA MGRIP2 AR-15 / M4 Drop On Magazine Well Grip

Turn your lower receiver into a built-in handstop and a fast-feed funnel.

The MGRIP2 clamps around any mil-spec AR-15 / M4 magazine well and gives you a forward pistol style grip that centers the support hand, shortens the rifle’s overall profile in CQB, and keeps body heat off the magazine. At the same time its flared "ears" act as a mini funnel, guiding fresh mags straight into the well for quicker, fumble-free reloads.

• One piece glass fiber reinforced polymer – only ≈ 3.8 oz but tough enough for door kicking.

• Tool-less install: two captive cross-bolts squeeze the halves, no receiver mods, no gunsmith.

• Deep front finger groove and stippled side panels stay tacky with gloves, sweat or rain.

• Compatible with GI and polymer mags (PMAG, Lancer, Hex, etc.) and works on billet or forged lowers as long as the magazine well follows mil-spec outside geometry.

• Molded slot accepts most factory trigger-guard tabs; leaves ample room for gloved fingers inside the trigger guard.

the MGRIP2 gives you the speed of a flared mag-well plus the control of a vertical grip, without adding an ounce of rail-mounted bulk.